skip to main content
OSTI.GOV title logo U.S. Department of Energy
Office of Scientific and Technical Information

Title: Transportation properties of a high-current magnetically insulated transmission line and dynamics of the electrode plasma

Journal Article · · Plasma Physics Reports
; ; ; ; ; ; ; ; ; ; ;  [1];  [2];  [1]
  1. Russian Research Centre Kurchatov Institute (Russian Federation)
  2. Russian Academy of Sciences, Institute for High Energy Densities, Joint Institute for High Temperatures (Russian Federation)

Results are presented from experimental studies of a section of a magnetically insulated transmission line (MITL) with a current density of up to 500 MA/cm{sup 2} and linear current density of up to 7 MA/cm (the parameters close to those in a fast-Z-pinch-driven fusion reactor projected at Sandia Laboratories). The experiments were performed in the S-300 facility (3 MA, 0.15 {Omega}, 100 ns). At high linear current densities, the surface of the ohmically heated MITL electrode can explode and a plasma layer can form near the electrode surface. As a result, the MITL can lose its transmission properties due to the shunting of the vacuum gap by the plasma produced. In this series of experiments, the dynamics of the electrode plasma and the dependence of the transmission properties of the MITL on the material and cleanness of the electrode surface were studied. It is shown experimentally that, when the current with a linear density of up to 7 MA/cm begins to flow along a model MITL, the input and output currents differ by less than 10% over a time interval of up to 230 ns for nickel electrodes and up to 350 ns for a line with a gold central electrode. No effect of the oil film present on the electrode surface on the loss of the transmission properties of the line was observed. It is also shown that electron losses insignificantly contribute to the total current balance. The experimental results are compared with calculations of the electrode explosion and the subsequent expansion of the plasma layer. A conclusion is made that the life-time of the model MITL satisfies the requirements imposed on the transmission lines intended for use in the projected thermonuclear reactor.

OSTI ID:
21400002
Journal Information:
Plasma Physics Reports, Vol. 34, Issue 7; Other Information: DOI: 10.1134/S1063780X08070064; Copyright (c) 2008 Pleiades Publishing, Ltd.; ISSN 1063-780X
Country of Publication:
United States
Language:
English