skip to main content

SciTech ConnectSciTech Connect

This content will become publicly available on June 30, 2017

Title: Additive manufacturing capabilities applied to inertial confinement confusion at Los Alamos National Laboratory

We describe the use at Los Alamos National Laboratory of additive manufacturing (AM) for a variety of jigs and coating, assembly, and radiography fixtures. Additive manufacturing has also been used to produce shipping containers of complex design that would be too costly to have fabricated using traditional techniques. The current goal for AM use in target fabrication is to increase target accuracy and rigidity. This has been realized by implementing AM into target stalk fabrication, allowing increased complexity to address target strength and the addition of features for alignment at facilities. As a result, we will describe the fabrication of these components and our plans to utilize AM in the future.
 [1] ;  [1] ;  [1]
  1. Los Alamos National Lab. (LANL), Los Alamos, NM (United States)
Publication Date:
OSTI Identifier:
Report Number(s):
Journal ID: ISSN 1536-1055
Grant/Contract Number:
Accepted Manuscript
Journal Name:
Fusion Science and Technology
Additional Journal Information:
Journal Volume: 70; Journal Issue: 2; Journal ID: ISSN 1536-1055
American Nuclear Society
Research Org:
Los Alamos National Lab. (LANL), Los Alamos, NM (United States)
Sponsoring Org:
Country of Publication:
United States
70 PLASMA PHYSICS AND FUSION TECHNOLOGY additive manufacturing; rapid prototype; inertial confinement fusion; high energy density plasma physics; coating; assembly