Grinding energy and physical properties of chopped and hammer-milled barley, wheat, oat, and canola straws
- Idaho National Laboratory (INL), Idaho Falls, ID (United States). Biofuels and Renewable Energy Technologies Dept.
- Univ. of Saskatchewan, Saskatoon, Saskatchewan (Canada). Dept. of Chemical and Biological Engineering
- Shenyang Agricultural University (China). Coll. of Engineering
- Univ. of Saskatchewan, Saskatoon, Saskatchewan (Canada). Dept. of Chemical and Biological Engineering
In the present study, specific energy for grinding and physical properties of wheat, canola, oat and barley straw grinds were investigated. The initial moisture content of the straw was about 0.13–0.15 (fraction total mass basis). Particle size reduction experiments were conducted in two stages: (1) a chopper without a screen, and (2) a hammer mill using three screen sizes (19.05, 25.4, and 31.75 mm). The lowest grinding energy (1.96 and 2.91 kWh t-1) was recorded for canola straw using a chopper and hammer mill with 19.05-mm screen size, whereas the highest (3.15 and 8.05 kWh t-1) was recorded for barley and oat straws. The physical properties (geometric mean particle diameter, bulk, tapped and particle density, and porosity) of the chopped and hammer-milled wheat, barley, canola, and oat straw grinds measured were in the range of 0.98–4.22 mm, 36–80 kg m-3, 49–119 kg m-3, 600–1220 kg m-3, and 0.9–0.96, respectively. The average mean particle diameter was highest for the chopped wheat straw (4.22-mm) and lowest for the canola grind (0.98-mm). The canola grinds produced using the hammer mill (19.05-mm screen size) had the highest bulk and tapped density of about 80 and 119 kg m-3; whereas, the wheat and oat grinds had the lowest of about 58 and 88–90 kg m-3. The results indicate that the bulk and tapped densities are inversely proportional to the particle size of the grinds. The flow properties of the grinds calculated are better for chopped straws compared to hammer milled using smaller screen size (19.05 mm).
- Research Organization:
- Idaho National Lab. (INL), Idaho Falls, ID (United States)
- Sponsoring Organization:
- DOE - EE
- DOE Contract Number:
- DE-AC07-05ID14517
- OSTI ID:
- 1119887
- Report Number(s):
- INL/JOU-12-26726
- Journal Information:
- Biomass and Bioenergy, Vol. 60; ISSN 0961-9534
- Publisher:
- Elsevier
- Country of Publication:
- United States
- Language:
- English
Similar Records
Effect of process variables on the quality attributes of briquettes from wheat, oat, canola and barley
Direct measures of mechanical energy for knife mill size reduction