Recovery of monomers from recycled plastics
- Univ. of North Dakota Energy & Environmental Research Center, Grand Forks, ND (United States)
- Fina Oil and Chemical Co., Deer Park, TX (United States)
Plastics make up approximately 20% by volume of the material disposed of in landfills in the United States. The increased interest in recycling has focused attention on ways to expand our current recycling efforts. Types of commodity plastics typically found in a postconsumer stream include high-density polyethylene (HDPE), low-density polyethylene (LDPE), linear low-density polyethylene (LLDPE), polypropylene (PP), polyethylene terephthalate (PET), polyvinyl chloride (PVC), and polystyrene (PS). In addition to plastics such as these, a number of organic and inorganic constituents will be present, including paper, paint, food, and various metals. These constituents are present as a result of introduction into the plastics during manufacturing (to give a plastic product selective properties) or as residual matter from use by the consumer. The Energy & Environmental Research Center (EERC) is one of several groups in the United States and Europe that, over the last several years, has worked toward developing a process to thermally break down postconsumer plastics to hydrocarbon liquids and gases. Such a process, sometimes referred to as thermal depolymerization, thermal recycling, or feedstock recycling, produces hydrocarbon liquids and gases that could be used for the manufacture of new plastics or other petroleum products. The specific slate of products depends on processing conditions. Subsequent studies have identified several relatively high-value products possible from the process, including ethylene (C{sub 2}{sup -}), propylene (C{sub 3}{sup -}), and butylenes. Past work at the EERC has also indicated that optimal processing conditions exist for these olefin yields. The proposed the EPA work is based on information, presented here, that was obtained in studies completed at the EERC under the sponsorship of the American Plastics Council (APC) and the U.S. Department of Energy (DOE).
- OSTI ID:
- 111500
- Report Number(s):
- CONF-9504110-; TRN: 95:005009-0042
- Resource Relation:
- Conference: 21. Environmental Protection Agency (EPA) annual Risk Reduction Engineering Laboratory research symposium, Cincinnati, OH (United States), 4-6 Apr 1995; Other Information: PBD: 1995; Related Information: Is Part Of 21st Annual RREL research symposium: Abstract proceedings; PB: 398 p.
- Country of Publication:
- United States
- Language:
- English
Similar Records
Climate Impact of Primary Plastic Production
Neural network hardware and software solutions for sorting of waste plastics for recycling