- INSTITUTE OF PHYSICS PUBLISHING SMART MATERIALS AND STRUCTURES Smart Mater. Struct. 16 (2007) S179S186 doi:10.1088/0964-1726/16/1/S18
- Experimental study on rate dependence of macroscopic domain and stress hysteresis in NiTi shape memory alloy strips
- CHAPTER SEVEN PLASTIC COLLAPSE and LIMIT ANALYSIS
- Wear 259 (2005) 309318 The role of phase transition in the fretting behavior of
- MECH 303 Chapter 6 Chapter 6 Plane Problems on Thermal Stresses
- Hong Kong University of Science & Technology 1 Mech202 Tutorial 12
- 5.4 Nucleation and growth theories of phase transitions (kinetics) Stability, metastability and instability
- This article appeared in a journal published by Elsevier. The attached copy is furnished to the author for internal non-commercial research
- International Journal of Modern Physics B Vol. 24, Nos. 1 & 2 (2010) 8593
- CHAPTER TWO THICK-WALLED CYLINDERS and
- Materials Science and Engineering A 425 (2006) 278285 Spherical indentation hardness of shape memory alloys
- Hong Kong University of Science & Technology 1 Mech202 Tutorial 8
- CHAPTER ONE STRESS, STRAIN, ENERGY and FAILURE
- Wear 260 (2006) 509522 Role of phase transition in the unusual microwear behavior of
- 3.5 Nucleation and temporal evolution of inclusion kinetics of interface In the analysis of section 3.4, the equilibrium shape we considered is actually a static one
- Hong Kong University of Science & Technology 1 Mech202 Tutorial 11
- Author's personal copy Determination of plastic yield stress from spherical indentation slope curve
- For small-deflection theory, the derivative terms are considered small. Therefore, if is considered small compared with x
- 3.4 Equilibrium shape of second phase domains (microstructure patterns) 3.4.1 Microstructure patterns and deformation domains in materials and structures
- 2.3 Continuum aspects of crack Nonlinear Theories In last section, we see that Irwin's generalization of the Griffith's concept provides us
- Published by AMSS Press, Wuhan, China Acta Mechanica Solida Sinica, Vol. 22, No. 5, October, 2009 ISSN 0894-9166
- CHAPTER TWO THICK-WALLED CYLINDERS and
- MECH 303 Chapter 5 Chapter 5 Torsion
- 2.4 Continuum aspects of crack Dynamic fracture There are two ways for a crack system to change from the Quasistatic (crack grows
- Frequency-dependent temperature evolution in NiTi shape memory alloy under cyclic loading This article has been downloaded from IOPscience. Please scroll down to see the full text article.
- Ambient effect on damping peak of NiTi shape memory alloy Yongjun He, Hao Yin, Runhua Zhou, Qingping Sun
- Macroscopic equilibrium domain structure and geometric compatibility in elastic phase transition of thin plates
- Published by AMSS Press, Wuhan, China Acta Mechanica Solida Sinica, Vol. 22, No. 5, October, 2009 ISSN 0894-9166
- The role of martensite reorientation in the fretting behaviour of nickel titanium shape memory alloy
- Effects of structural and material length scales on stress-induced martensite macro-domain patterns in tube configurations
- Pleasecitethisarticleinpressas:L.Qianetal.,NanofrettingbehaviorsofNiTishapememoryalloy,Wear(2007),doi:10.1016/j.wear.2006.12.045 ARTICLE IN PRESS+Model
- Wearless scratch on NiTi shape memory alloy due to phase transformational shakedown
- Shakedown analysis of shape memory alloy structures
- Analysis of spherical indentation of superelastic shape memory alloys
- Fretting wear behavior of superelastic nickel titanium shape memory alloy
- Effect of elastic matrix constraint on the tensile deformation of NiTi superelastic fiber
- Anomalous relationship between hardness and wear properties of a superelastic nickeltitanium alloy
- Elastic solutions of a cylindrical rod containing periodically distributed inclusions
- Analysis of a transversely isotropic rod containing a single cylindrical inclusion with axisymmetric eigenstrains
- Thermal expansion of composites with shape memory alloy inclusions and elastic matrix
- Phase transformation in superelastic NiTi polycrystalline micro-tubes under tension and torsionfrom
- On the elastic axisymmetric deformation of a rod containing a single cylindrical inclusion
- MECH 202 Mechanics of Solid II (Fall 2010-2011) Prerequisites: MECH 101
- CHAPTER THREE SYMMETRIC BENDING OF CIRCLE PLATES
- CHAPTER FOUR ELASTIC FOUNDATIONS
- CHAPTER FOUR ELASTIC FOUNDATIONS
- CHAPTER FIVE TORSION, UNSYMMETRIC BENDING
- A cylinder with end caps is to have inner radius b = 10mm. It must carry internal pressure 140MPa with safety factor SF = 1.7. Failure is defined as the onset of
- Tutorial 5: Example: Derive the values at r = 0 in Case of 4 by appropriate
- Hong Kong University of Science & Technology 1 Mech202 Tutorial 9
- MECH 303 Chapter 5 In the case of multiply-connected body, shown below
- MECH 303 Chapter 7 Chapter 7 Theory of Spatial Problems
- MECH 503 Introduction to Mechanics of Defects in Solids Course Description
- Chapter 1 Introduction Chapter 1. Introduction
- Chapter 2 Cracks and Fundamentals of Fracture *Reference books: (1) B. Lawn and Shaw, "Fracture of Brittle Solids", (1975, 1993)
- 2.2 Continuum aspects of crack linear theory From "its nucleation" stage to a "well-developed" crack, then propagation stage. We
- MECH 503 Introduction to Mechanics of Defects in Solids Chapter 3 Theory of Inclusions and Inhomogeneities
- Journal of the Mechanics and Physics of Solids 54 (2006) 15681603
- A closed cylinder with inner and outer radii of 60 and 80mm, respectively, is subjected to an internal pressure p1 = 30MPa and axial load P = 650kN.
- Key references for Chapter 3 1. T. Mura, Micromechanics of defects in solids, Kluwer Academic Publishers,
- Stress-induced phase transformation and detwinning in NiTi polycrystalline shape memory alloy tubes
- An inclusion theory for the propagation of martensite band in NiTi shape memory alloy
- Numerical Simulation for Stress-induced Phase Transformation of SMAs Tube under Tension
- 2.5 Atomistic Aspects of Crack Propagation Understanding of crack propagation: Continuum levels Atomistic or molecular
- CHAPTER ONE STRESS, STRAIN, ENERGY and FAILURE
- Author's personal copy On non-monotonic rate dependence of stress hysteresis of superelastic shape
- Journal of the Mechanics and Physics of Solids 48 (2000) 21632182
- Rate-dependent domain spacing in a stretched NiTi strip Y.J. He, Q.P. Sun *
- Hong Kong University of Science & Technology 1 Mech202 Tutorial 10
- Smart Mater. Struct. 9 (2000) 693700. Printed in the UK PII: S0964-1726(00)12453-X Effect of microstructure on the
- MECH 202 -----Mechanics of Solid II (Fall 2010-2011) Course Description: Bi-axial stress state and failure criteria; thick-walled
- Loading rate dependency of maximum nanoindentation depth in nano-grained NiTi shape memory alloy
- Determination of transformation stresses of shape memory alloy thin films: A method based on spherical indentation
- The initiation and growth of macroscopic martensite band in nano-grained NiTi
- CHAPTER THREE SYMMETRIC BENDING OF
- Scaling relationship on macroscopic helical domains in NiTi tubes Y.J. He, Q.P. Sun *
- Chapter Eight Energy Method
- 1. The end of a semi-infinite beam on a Winkler foundation is simply
- Philosophical Magazine, 1 Nov1 Dec 2003 Vol. 83, Nos. 3134, 37533764
- CHAPTER SIX CURVED BEAM AND FRAME ANALYSYS
- PERGAMON International Journal of Solids and Structures 37 (2000) 1577-1594 INTERNATIONAL JOURNAL Of
- THEORETICAL & APPLIED MECHANICS LETTERS 1, 044001 (2011) Simulation of bacterial flagellar phase transition by non-convex and
- ACTA MECHANICA SINICA (English Series), Vol.16, No.4, November 2000 ISSN 0567-7718 The Chinese Society of Theoretical and Applied Mechanics
- Qing-Ping Sun Terry Ting Xu
- School of MPE, Nanyang Technological University,
- Smart Mater. Struct. 9 (2000) 693-700. Printed in the UK PII: S0964-1726(00)12453-X Effect of microstructure on the
- Depth dependency of indentation hardness during solid-state phase transition of shape memory alloys
- Helical domain patterns in tube configurations: effect of geometry length scales
- ... ACTA MECHANICA SINICA (English Series), Vol.16, No.4, November 2000 ISSN 0567-7718 The Chinese Society of Theoretical and Applied Mechanics
- MECH 3020 TUTORIAL 8 XIA, Minglu
- MECH 3020 TUTORIAL 6 Minglu, Xia
- Derek, DING Department of Mechanical Engineering
- Derek, DING Department of Mechanical Engineering
- MECH 3020 Tutorial 10 By XIA, Minglu
- Derek, DING Department of Mechanical Engineering
- MECH 3020 Tutorial 4 By Minglu, Xia
- MECH 202 -----Mechanics of Solid II (Fall 2010-2011) Course Description: Bi-axial stress state and failure criteria; thick-walled
- Derek, DING Department of Mechanical Engineering
