- Effect of strain rate on the yielding mechanism of amorphous metal foam Joseph P. Schramm,1,a
- International Journal of Impact Engineering 34 (2007) 874882 Scaling the response of circular plates subjected to large and
- Experimental crack identication using electrical impedance tomography R. Lazarovitch, D. Rittel*, I. Bucher
- Materials Science and Engineering A 447 (2007) 6570 Thermomechanical characterization of pure polycrystalline tantalum
- To appear in J. Mech. Phys. Solids (2010) MODELING ADIABATIC SHEAR FAILURE FROM ENERGY
- A Shear-compression Specimen for Large Strain Testing by D. Rittel, S. Lee and G. Ravichandran
- ON THE ISOTROPY OF THE DYNAMIC MECHANICAL AND FAILURE PROPERTIES OF SWAGED TUNGSTEN HEAVY ALLOYS
- Materials Science and Engineering A 432 (2006) 191201 The mechanical response of pure iron at high strain
- UNCORRECTED 2 Optimum location of a three strain gauge rosette for measuring mixed
- To appear in Int. J. Impact Engineering, 2007 Transverse impact of free-free square
- Transient Temperature Measurement Using Embedded Thermocouples
- Dynamic fracture of berylium-bearing bulk metallic glass systems: A cross-technique comparison
- Mode-mixity and dynamic failure mode transitions in polycarbonate
- Adiabatic shear failure of a syntactic polymeric foam Faculty of Mechanical Engineering, Technion, Israel Institute of Technology, 32000 Haifa, Israel
- A hybrid experimentalnumerical investigation of dynamic shear fracture
- Annals of the CIRP Vol. 56/1/2007 3D Reconstruction and Visualization of Microstructure Surfaces from 2D Images
- Application of ac tomography to crack identification H. Saguy and D. Rittela
- Infrared Temperature Sensing of Mechanically Loaded Specimens: Thermal Analysis
- Experimentation and modeling of inclined ballistic impact in thick polycarbonate plates
- The inuence of temperature on dynamic failure mode transitions
- International Journal of Fracture 104: 89103, 2000. 2000 Kluwer Academic Publishers. Printed in the Netherlands.
- Microstructural aspects of adiabatic shear failure in annealed Ti6Al4V
- AN ANALYSIS OF NANOINDENTATION IN ELASTO-PLASTIC SOLIDS
- Large Strain Mechanical Behavior of 1018 Cold-Rolled Steel over a Wide Range of Strain Rates
- To appear in International Journal of Fracture A NOTE ON THE DYNAMIC FAILURE OF PMMA
- To appear in Int. J. Impact Engineering (2009) A study of inclined impact in polymethylmethacrylate
- Alternating current flow in internally flawed conductors: A tomographic H. Saguy and D. Rittela
- To appear in International Journal of Impact Engineering GEOMETRICAL IMPERFECTION AND ADIABATIC SHEAR BANDING
- Large Deformation of Nitinol Under Shear Dominant Loading
- To appear in International Journal of Impact Engineering Springback of circular clamped armor steel plates subjected to
- Tensile Fractureof Coarse-Grained Cast AusteniticManganese Steels
- Journal of the Mechanics and Physics of Solids 51 (2003) 14131431
- International Journal of Fracture 212: 8798, 2001. 2001 Kluwer Academic Publishers. Printed in the Netherlands.
- Int J Fract DOI 10.1007/s10704-010-9475-8
- A shear compression disk specimen with controlled stress triaxiality under quasi-static
- On the conversion of plastic work to heat during high strain rate deformation of glassy polymers
- NDT&E International ] (]]]]) ]]]]]] Flaw detection in metals by the ACPD technique: Theory and
- International Journal of Fracture 99: 199209, 1999. 1999 Kluwer Academic Publishers. Printed in the Netherlands.
- To appear in Journal of the Mechanics and Physics of Solids A METHODOLOGY TO ASSESS THE RATE AND
- To appear in the Journal of theMechanics and Physics of Solids (2010) Static and Dynamic Fracture of Transparent Nanograined Alumina
- THERMOMECHANICAL BEHAVIOR OF SINGLE CRYSTALLINE TANTALUM IN THE STATIC AND DYNAMIC REGIME
- Technical note: Determination of the Johnson-Cook material parameters
- A DIFFERENT VIEWPOINT ON ADIABATIC SHEAR LOCALIZATION Faculty of Mechanical Engineering
- An analysis of nanoindentation in linearly elastic solids , D. Rittel b
- To appear in Physical Review Letters DYNAMIC RECRYSTALLIZATION AS A POTENTIAL CAUSE FOR
- To appear in Mechanics of Materials (2008) Thermo-mechanical aspects of adiabatic shear failure of AM50 and
- c:\docume~1\eesweb~1\locals~1\temp\bcl technologies\easypdf 5\@bcl@c40f325e\@bcl@c40f325e.doc 02/09/2007 1
- To appear in Experimental Mechanics SIMULTANEOUS TRANSIENT TEMPERATURE SENSING OF IMPACTED
- Pressure sensitivity of adiabatic shear banding in metals E. Hanina, D. Rittel,a ,b
- International Journal of Impact Engineering 34 (2007) 859873 Scaling the response of circular plates subjected to large and
- A Numerical Study of the Applicability of the Shear Compression Specimen to Parabolic Hardening Materials
- Adiabatic Shear Failure and Dynamic Stored Energy of Cold Work D. Rittel,* Z. G. Wang, and M. Merzer
- Hysteretic thermal behavior of amorphous semi-aromatic polyamides , G. Landsberg a
- Bridging thin and thick skin solutions for alternating currents in cracked H. Saguy and D. Rittela
- Numerical Validation of the Shear Compression Specimen. Part II: Dynamic Large Strain Testing
- Numerical Validation of the Shear Compression Specimen. Part I: Quasi-static Large Strain Testing
- Dynamic mechanical and fracture properties of an infiltrated TiC-1080 steel cermet
- Static and dynamic mechanical damage mechanisms in TiC-1080 steel cermets
- Failure modes of electrospun nanofibers E. Zussman,a)
- Hysteretic heating of modified poly(methylmethacrylate) D. Rittela,*, N. Eliasha
- International Journal of Fracture 117: 101112, 2002. 2002 Kluwer Academic Publishers. Printed in the Netherlands.
- On Testing of Charpy Specimens Using the One-point Bend Impact Technique
- Fragmentation of a porous viscoelastic material: Implications to magma fragmentation
- Large strain constitutive behavior of OFHC copper over a wide range of strain rates using the shear
- On crack-tip cooling during dynamic crack initiation O. Bougaut 1
- An investigation of the heat generated during cyclic loading of two glassy polymers. Part II: Thermal analysis
- An investigation of the heat generated during cyclic loading of two glassy polymers. Part I: Experimental
- Experimental investigation of transient thermoplastic eects in dynamic fracture
- A Model for the Time Response of Solid-embedded Thermocouples
- Int. J. Solids Structures Vol. 29, No. 23. pp. 2881-2895. 1992 Printed in Great Britain.
- Materials Science and Engineering A 487 (2008) 405409 Static and dynamic mechanical properties of infiltrated
- International Journal of Fracture 97: 321336, 1999. c 1999 Kluwer Academic Publishers. Printed in the Netherlands.
- Journal of the Mechanics and Physics of solids 53 (2005) 565596
- MICROSTRUCTURAL EFFECTS ON ADIABATIC SHEAR BAND FORMATION S. Osovski1
- (This is a sample cover image for this issue. The actual cover is not yet available at this time.) This article appeared in a journal published by Elsevier. The attached
