Home

About

Advanced Search

Browse by Discipline

Scientific Societies

E-print Alerts

Add E-prints

E-print Network
FAQHELPSITE MAPCONTACT US


  Advanced Search  

 
Pseudo-elastic deformation behavior in a Ti/Mo-based alloy , M. Aindow a,*, S.P. Alpay a
 

Summary: Pseudo-elastic deformation behavior in a Ti/Mo-based alloy
T. Zhou a
, M. Aindow a,*, S.P. Alpay a
, M.J. Blackburn a
, M.H. Wu b
a
Department of Metallurgy and Materials Engineering, Institute of Materials Science, University of Connecticut, Storrs, CT 06269-3136, USA
b
Memry Corporation, Bethel, CT 06801, USA
Received 23 September 2003; received in revised form 13 October 2003; accepted 13 October 2003
Abstract
It is shown that the pseudo-elastic response in a series of TiMoVNbAl alloys with 811 wt.% Mo is highly sensitive to both
composition and heat treatment. Recovery of up to 3.0% strain has been observed but it appears that this may not be due to re-
versible formation of a00
martensite.
2003 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
Keywords: Titanium alloys; Pseudo-elasticity; Bending test; Tension test; Deformation structure
1. Introduction
Commercial Ti alloys are generally classified into
three categories, a, a b, and b alloys depending on the

  

Source: Alpay, S. Pamir - Department of Materials Science and Engineering, University of Connecticut

 

Collections: Materials Science