Home

About

Advanced Search

Browse by Discipline

Scientific Societies

E-print Alerts

Add E-prints

E-print Network
FAQHELPSITE MAPCONTACT US


  Advanced Search  

 
Krystyna Brzezinska (kbrzez@mrl.ucsb.edu) ADD SAMPLES to the running GPC (only red icon is active)
 

Summary: GPC-Water
Manual
Krystyna Brzezinska (kbrzez@mrl.ucsb.edu)
May 2011
ADD SAMPLES to the running GPC (only red icon is active):
1. Edit- Alter Running Sample- OK. Red and green icons should be active.
2. Insert rows, change name, vial #. Don't forget to load carousel with vials.
3. Don't change rows: Condition Columns; Equilibrate; Purge Injector; Purge Detector; Ramp Flow Down, or
PDA lamp OFF; Injection volume 100 L and # of injections 1.
4. Click on the GREEN ICON. Only red icon should be active. For automatic results use "Run and Report",
continue on Fault- Run.
5. If you are not satisfied with integration you can change it (see analysis) and print it again.
RUN SAMPLE when instrument idle (only green icon is available):
1. Delete unused rows. Insert more rows if necessary- change name, vial #. Load carousel with your vials.
2. Don't change rows: Condition Columns (ramp flow up to 1 mL); Equilibrate; Purge Injector; Purge Detector;
Condition Columns, Ramp Flow Down, or PDA lamp OFF; Injection volume 100 L and # of injections 1.
3. Click on the green icon. For automatic results use "Run and Report", continue on Fault- Run.
4. If you are not satisfied with integration you can change it (see analysis) and print it again.
ANALYSIS:
1. MOLECULAR WEIGHT: Open "Browse Project" from the Empower- Results- open your run with left

  

Source: Akhmedov, Azer - Department of Mathematics, University of California at Santa Barbara

 

Collections: Mathematics