Test Plan for the Boiling Water Reactor Dry Cask Simulator
- Sandia National Lab. (SNL-NM), Albuquerque, NM (United States)
The thermal performance of commercial nuclear spent fuel dry storage casks are evaluated through detailed numerical analysis . These modeling efforts are completed by the vendor to demonstrate performance and regulatory compliance. The calculations are then independently verified by the Nuclear Regulatory Commission (NRC). Carefully measured data sets generated from testing of full sized casks or smaller cask analogs are widely recognized as vital for validating these models. Recent advances in dry storage cask designs have significantly increased the maximum thermal load allowed in a cask in part by increasing the efficiency of internal conduction pathways and by increasing the internal convection through greater canister helium pressure. These same vertical, canistered cask systems rely on ventilation between the canister and the overpack to convect heat away from the canister to the environment for both above and below-ground configurations. While several testing programs have been previously conducted, these earlier validation attempts did not capture the effects of elevated helium pressures or accurately portray the external convection of above-ground and below-ground canistered dry cask systems. The purpose of the investigation described in this report is to produce a data set that can be used to test the validity of the assumptions associated with the calculations presently used to determine steady-state cladding temperatures in modern vertical, canistered dry cask systems. The BWR cask simulator (BCS) has been designed in detail for both the above-ground and below-ground venting configurations. The pressure vessel representing the canister has been designed, fabricated, and pressure tested for a maximum allowable pressure (MAWP) rating of 24 bar at 400 deg C. An existing electrically heated but otherwise prototypic BWR Incoloy-clad test assembly is being deployed inside of a representative storage basket and cylindrical pressure vessel that represents the canister. The symmetric single assembly geometry with well-controlled boundary conditions simplifies interpretation of results. Various configurations of outer concentric ducting will be used to mimic conditions for above and below-ground storage configurations of vertical, dry cask systems with canisters. Radial and axial temperature profiles will be measured for a wide range of decay power and helium cask pressures. Of particular interest is the evaluation of the effect of increased helium pressure on allowable heat load and the effect of simulated wind on a simplified below ground vent configuration. While incorporating the best available information, this test plan is subject to changes due to improved understanding from modeling or from as-built deviations to designs. As-built conditions and actual procedures will be documented in the final test report.
- Research Organization:
- Sandia National Lab. (SNL-NM), Albuquerque, NM (United States)
- Sponsoring Organization:
- USDOE National Nuclear Security Administration (NNSA)
- DOE Contract Number:
- AC04-94AL85000
- OSTI ID:
- 1227236
- Report Number(s):
- SAND-2015-10256; 613825; TRN: US1500904
- Country of Publication:
- United States
- Language:
- English
Similar Records
Test Plan for the Horizontal Dry Cask Simulator
Description of a Dry Cask Simulator for Measuring Internal and External Thermal-Hydraulic Performance
Related Subjects
12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE WASTES FROM NUCLEAR FACILITIES
CASKS
CYLINDRICAL CONFIGURATION
DRY STORAGE
BWR TYPE REACTORS
HELIUM
VALIDATION
PRESSURE VESSELS
CONVECTION
SIMULATORS
SPENT FUELS
DESIGN
COMPUTERIZED SIMULATION
HEAT
PERFORMANCE
HEATING LOAD
STEADY-STATE CONDITIONS
DUCTS
EVALUATION
VENTILATION
WIND
MATHEMATICAL MODELS
TEMPERATURE RANGE 0400-1000 K
PRESSURE RANGE MEGA PA 01-10
TEMPERATURE DISTRIBUTION
PRESSURE DEPENDENCE
TESTING
INCOLOY ALLOYS